The Lines tab in the Drawing View Style dialog box defines the appearance of view annotations that use the drawing view style.

Drawing View

Sets options for drawing view border display.

Line Type

Specifies the line type for the drawing view border.

Line Width

Specifies the line width for the drawing view border.

Note:

To see the effect of changes to these settings, the Show drawing view border check box on the General tab (Drawing View Properties dialog box) must be selected.

View Annotation

Terminator

Specifies the appearance of the terminator lines and arrows.

Display

Controls the display of terminators on the cutting plane line or the viewing plane line. Options are None or Both.

Thin terminator lines

Controls the thickness of the terminator lines.

Type

Specifies the symbol to display on the terminator lines. Options include Arrows (filled, hollow, open), Slash, Back Slash, Blank, Circle, and Dot.

Length= __ x Font size

Specifies the length of the terminator symbol as a ratio of font size.

Cutting Plane

Point toward

Specifies that the terminator lines point toward the cutting plane line.

Point away

Specifies that the terminator lines point away from the cutting plane line.

Style

Sets the style for the cutting plane line. Options are Thick, Thick Corners Only, and Thick/Thin.

Thick line length = __ x Font size

Specifies the length of the thick portions of the cutting plane line. The value is multiplied by font size. This setting only applies to the Thick/Thin and Thick Corners Only options for Style.

Offset arrow

Offsets the cutting plane direction arrow along the length of the thick portion of the cutting plane line. Values are 0 through 1. This option applies to Thick/Thin and Thick Corners Only cutting plane line styles.

Value	Cutting Plane Arrow Location
0	Arrows are located at the outside end of the thick portion.
0.5	Arrows are centered on the thick portion.
1	Arrows are located at the inside end of the thick portion.

Line

Line type

Specifies the line type for terminator lines used in captions. These include dashed and solid line types.

Line width

Specifies the line width for terminator lines used in captions.

Viewing Plane

Single

Specifies that a single terminator line is displayed.

Double

Specifies that a double terminator line is displayed.