In the Simulation Results environment, beam results now are consolidated to reduce the number of results reported. When the beam results are identical for both ends of the beam, EndA and EndB, the results are combined into one value instead of listing them separately. This reduces the number of reported results by half, and simplifies the results display.
Example:
Instead of showing the results for Beam EndA Plane1 Moment and Beam EndB Plane1 Moment, a single result is reported for Beam Plane 1 Moment.
This change is visible in the Simulation Results environment, in the following locations:
Result types available for selection from the Result Component list on the Home tab→Data Selection group.
Plot names listed in the Simulation pane for these types of plots:
Beam End Reactions
Stress
For more information, see: